FAQ's

  • Can Teg-Tab’s be made in different colours?
    Yes on request, please note minimum quantities and lead times apply
  • Can Teg-Tab’s be used on an angle?
    Definitely! Teg-Tab’s are designed to allow for a 45 degree angle.
  • Can Teg-Tab’s be used on wall molding that is 7/8"?
    Yes, match-up your grid and tile sizes and use one of the 9/16" wall mold options.
  • Are they available in sizes not shown?
    Yes on request, please note minimum quantities and lead times apply
  • Can Teg-Tab’s be used under seismic restrictions?
    Yes, check out how they perform. When used with the Armstrong BERC or USG ACM7 clip, the Teg-Tab becomes essentially cosmetic and is not subject to seismic load requirements. Only when used IN PLACE of a seismic clip, requiring rivets, are Teg-Tabs subject to seismic code requirements.
  • Must Teg-Tabs be riveted in place?
    No, Teg-Tabs snap into place and stay in place. Riveting may be necessary for seismic code requirements, in which case, rivet right through the tab. When used with the Armstrong BERC or USG ACM7 clip, the Teg-Tab becomes essentially cosmetic and is not subject to seismic load requirements. Only when used IN PLACE of a seismic clip, requiring rivets, are Teg-Tabs subject to seismic code requirements.
  • Are Teg-tab’s fire rated?
    Definitely, check how they perform under these conditions
  • Where can I purchase Teg-Tabs?
    Teg-Tabs are available here on our web store, and at select suppliers around the country. Please contact Synergistic Solutions for a supplier nearest you.
  • Can I get Teg-Tab samples?
    Sure. Just give us a call - we'll set you up.